THÔNG SỐ KỸ THUẬT:
Software:
| ● Cisco IOS XE Software Release 17.6.1 or later |
Supported wireless LAN controllers:
| ● Cisco Catalyst 9800 Series Wireless Controllers |
| ● Cisco 3504, 5520, and 8540 Wireless Controllers and Cisco Virtual Wireless Controller |
| Note: C9130AXE-STA-x is not supported on AireOS controllers |
802.11ac:
| ● 8×8 downlink MU-MIMO with eight spatial streams |
| ● PHY data rates up to 3.4 Gbps (8×8 80 MHz or Dual 4×4 80+80 MHz on 5GHz) |
| ● Wi-Fi Protected Access (WPA) 3 support |
802.11ax:
| ● 8×8 uplink/downlink MU-MIMO with eight spatial streams |
| ● Uplink/downlink OFDMA |
| ● PHY data rates up to 5.38 Gbps (8×8 80 MHz or Dual 4×4 80+80 MHz on 5GHz and 4×4 20 MHz on 2.4) |
| ● WPA3 support |
Integrated antenna:
| ● 2.4 GHz: Peak gain 4 dBi, internal antenna, omnidirectional in azimuth |
| ● 5 GHz: Peak gain 6 dBi, internal antenna, omnidirectional in azimuth |
External antenna with Smart antenna connector:
| ● The Cisco Catalyst 9130AXE Access Point is certified for use with antenna gains up to 13 dBi (2.4 GHz and 5 GHz) |
| ● Cisco offers the industry’s broadest selection of antennas, delivering optimal coverage for a variety of deployment scenarios |
| ● Supports Self-Identifiable Antennas (SIA) on the smart antenna connector |
| ● Smart antenna connector is a compact multi-RF connector with 8-DART interface |
| ● Requires the AIR-CAB002-D8-R= 2 ft smart antenna connector when used with antennas with a RP-TNC connector |
| ● Requires the AIR-CAB003-D8-N= 3 ft smart antenna connector when used with AIR-ANT2513P4M-N= antenna |
Interfaces:
| ● 1x 100, 1000, 2500, 5000 Multigigabit Ethernet (RJ-45) – IEEE 802.3az |
| ● Management console port (RJ-45) |
| ● USB 2.0 at 4.5W (enabled via future software) |
Indicators:
| ● Status LED indicates boot loader status, association status, operating status, boot loader warnings, and boot loader errors |
Dimensions (W x L x H):
| ● Access point (without mounting brackets): 18.2 X 23.5 X 5.8 in. (59.70 X 46.23 X 14.8 cm) |
Weight:
| ● 15.5 lbs (7.03 Kg) |
Input power requirements:
| ● 802.3at Power over Ethernet Plus (PoE+), 802.3bt Cisco Universal PoE (Cisco UPOE ®) |
| ● Cisco power injector, AIR-PWRINJ6= |
| ● 802.3af PoE |
| ● Cisco power injector, AIR-PWRINJ5= (Note: This injector supports only 802.3af) |
System memory:
| ● 2048 MB DRAM |
| ● 1024 MB flash |
